Foxconn P35A Bedienungsanleitung PDF herunterladen (Seite 34)

► FOX Ratio Select

FOX Ratio is a number representing memory clock divided by CPU Clock. Select a memory

speed, a FOX Ratio number, and try increasing CPU FSB speed, then your PC can be

overclocked.

► CPU FSB Type

This item displays the current CPU Front Side Bus speed.

► Memory Target Frequency

This item displays the target Memory Bus speed which we want to overclock or underclock.

► CPU FSB Over Clock Choice

This item allows you to change the CPU Front Side Bus speed. The maximum value is current

CPU FSB speed plus 2400MHz. You shall be careful not to set too high a value to damage

your CPU.

► PCIE Frequency Over Clock(MHz)

This item is used to adjust the speed of PCI-Express slot. It may enhance the graphics card

speed.

► Spread Spectrum

If you enabled this function, it can signicantly reduce the EMI (ElectroMagnetic Interference)

generated by the system, so to comply with FCC regulation. But if overclocking is activated,

you better disable it.

► Memory Remap Feature

This item is used to set the memory remap feature.

[Enabled] : Allow remapping of overlapped PCI memory to go above the total physical memory.

[Disabled] : Do not allow remapping of memory.

► DRAM Frequency

This item is used to manually select a DRAM speed as a reference for overclocking. Select a

memory speed, a FOX Ratio number, and try increasing CPU FSB speed, then your PC can

be overclocked. [Auto] means the memory speed is decided by the SPD device on DDR2

module.

► Congure DRAM Timing by SPD

This item is used to enable/disable provision of DRAM timing by SPD device. The Serial

Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory

module. It contains important information about the module's speed, size, addressing mode

and various other parameters, so that the motherboard memory controller (chipset) can better

access the memory device.

► Memory Hole

This item is used to set the memory hole. The available values are [Disabled] and [15MB-

16MB].

Some special ISA cards require this area of memory for them to work properly. Enabling this

function reserves the memory area for the card's use. In some cases, it may also prevent the

system from accessing memory above 15MB. If you enable this function, 1MB of RAM (the

15th MB) will be reserved and is therefore not available for the OS' use. Since ISA cards are a

thing of the past, you should always disable this feature.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 116 117

Keine Kommentare

Foxconn P35A Bedienungsanleitung Seite 34